what material is this..was the stain always there or did it develop later.  Was it fabricated with a CNC machine?  Looks like it might be from the CNC  

On Sat, Feb 12, 2011 at 2:37 PM, Lorne Greenberg <lorne@fabracleenstoneandtilecare.com> wrote:
I am going to test a poultice on Tuesday, I just wanted to send these pics
to see if someone has a thought as to what this could be.  If you look
closely at the picture from underneath you can see a faint dark line there
too.  In person you can see it better.  So this couldn't be a caulk issue
right?  Its only on that edge and obviously there is no caulk there.
Thoughts?
-Lorne

--
Powered by http://DiscussThis.com
Visit list archives, subscribe, unsubscribe or change your subscription preferences:
http://www.discussthis.com/members/sccpartners@stoneandtilepros.com
Start a new conversation (thread): sccpartners@stoneandtilepros.com




--
Frederick M. Hueston PhD
www.stoneforensics.com
www.stoneandtilepros.com
Recommended stone care products  http://www.stonecarecentral.com/?Click=2149

Many of my informational articles can be found at www.stoneandtilepros.com

Listen to my radio show at www.blogtalkradio.com/drfred
The Ultimate Stain Remover  www.GoDrFred.com

Cell 321-514-6845