Before I would do anything I would find out what the sealer is. It is possible it is a urethane based sealer. Go back to Home Depot and demand they give you an MSDS for the product. Its the law. Send it to me and I can tell you what it is and than we can recommend a stripper or method for removal

On Wed, Feb 16, 2011 at 10:24 AM, <info@restoreyourtiles.com> wrote:
That Sealer can be removed will alkaline based stripper. We have done it in the past. Superior's tech support they don't have a clue what to do in this type of case.
Sent via BlackBerry from T-Mobile

-----Original Message-----
From: "John Freitag" <jfreitag@thestoneandtileschool.com>
Date: Wed, 16 Feb 2011 10:19:57
To: Restoration and Maintenance<sccpartners@stoneandtilepros.com>
Reply-To:"Restoration and Maintenance" <sccpartners@stoneandtilepros.com>
Subject: RE: [sccpartners] removing excess sealer from travertine

Baird,

If the sealer has left a shine on the floor, it probably has some for solids
in it . I would try a good alkaline based stripper /degreaser to see if this
remove it. If that does not work contact the manufacturer to see what they
have to remove the sealer. my bet is thay have something to remove the
sealer or will tell you how to remove the sealer. I would start with an
alkaline based stripper / degreaser and mix it somewhat stronger than you
normally would.


John E. Freitag
President/Director
The Stone and Tile School
Office 407-567-7652
Cell 407-615-0134
jfreitag@thestoneandtileschool.com



www.thestoneandtileschool.com




-----Original Message-----
From: Baird Standish [mailto:bairdstandish@gmail.com]
Sent: Wednesday, February 16, 2011 8:32 AM
To: Restoration and Maintenance
Subject: [sccpartners] removing excess sealer from travertine

Hi,
We have been asked to correct a sealer problem.  My client recently
had a honed travertine floor installed.  They went to the tile store
and bought Superior Enhance and Seal and applied it themselves with a
sponge that was recommended to them.  It looked bad on the first go
round, so they applied another coat and now it is smeary and smudgy.
They say that the stone is darkened, so it must have absorbed into the
stone well enough.  I looked up the product and there is very little
info except that it is color enhancing and will give a wet look.  So
was looking for any tips on how to remove the excess.  Normally i
would try to polish out or maybe use a high grit twister pad.  But
this is a honed floor, so i don't want to mess up the finish.  Perhaps
a stripper would work, but then that would probably remove the sealer.
 If I were to go this route, what would be a good replacement sealer
(wet look).
Thanks.


--
________________________________________
>From the desk of
Baird Standish
Managing Partner
Facility Specialists, LLC
1616 Walnut St.
Philadelphia, PA 19103
Phone: 215-732-7505
Fax: 215-546-9160

--
Powered by http://DiscussThis.com
Visit list archives, subscribe, unsubscribe or change your subscription
preferences:
http://www.discussthis.com/members/sccpartners@stoneandtilepros.com
Start a new conversation (thread): sccpartners@stoneandtilepros.com






--
Powered by http://DiscussThis.com
Visit list archives, subscribe, unsubscribe or change your subscription preferences:
http://www.discussthis.com/members/sccpartners@stoneandtilepros.com
Start a new conversation (thread): sccpartners@stoneandtilepros.com




--
Powered by http://DiscussThis.com
Visit list archives, subscribe, unsubscribe or change your subscription preferences:
http://www.discussthis.com/members/sccpartners@stoneandtilepros.com
Start a new conversation (thread): sccpartners@stoneandtilepros.com




--
Frederick M. Hueston PhD
www.stoneforensics.com
www.stoneandtilepros.com
Recommended stone care products  http://www.stonecarecentral.com/?Click=2149

Many of my informational articles can be found at www.stoneandtilepros.com

Listen to my radio show at www.blogtalkradio.com/drfred
The Ultimate Stain Remover  www.GoDrFred.com

Cell 321-514-6845