Roger
,
Why
not use honing powders. By the time you figure the cost of the pads the powder
will probably be more cost effective and will guarantee a consistent finish.
where as the pads as they wear could give you an inconsistent
finish.
John E.
Freitag
President/Director
The
Stone and Tile School
Office
407-567-7652
Cell
407-615-0134
jfreitag@thestoneandtileschool.com
From: Roger Konarski
[mailto:qm144@yahoo.com]
Sent: Saturday, March 12, 2011 6:21
PM
To: Restoration and Maintenance
Subject: RE:
[sccpartners] Swirl Marks
|
I have
used the pads on two prior jobs and did not have the same problem.
Anyway I think we got the issue resolved, I tried to take a short cut to
remove the factory swirls, which is use only pads. Looks like we need to
cut the floor 1st with diamonds and then use pads. So far the initial
test looks promising. I don’t want
to use honing powders, the job is 8500 sq.ft. --- On Sat, 3/12/11, Darek Nicinski
<mail@rocklandstonerestoration.com>
wrote:
|
Powered by http://DiscussThis.com
Visit
list archives, subscribe, unsubscribe or change your subscription preferences
Start a new
conversation (thread)
Powered by http://DiscussThis.com
Visit
list archives, subscribe, unsubscribe or change your subscription preferences
Start a new
conversation (thread)