I want to thank you guys in helping with your suggestions yesterday. At the end it looks like the floor had a topical sealer that needed to be removed. Went to 180 honing powder & go to 220 up to 800 then polished with MB 12 at the end I ran a steel wool just for good measure. Tx for you support I pulled it off. Thanks again gentleman


Best Regards




Www.Stonemakeover.com

Schubert E Jacques
973-879-3400

On Mar 28, 2011, at 9:27 PM, Fred Hueston <fhueston@gmail.com> wrote:

I would also check the installation for excess moisture. This can also cause this haze through efflorescence.


On Sun, Mar 27, 2011 at 9:25 PM, Schubert Jacques <sejacques1124@aol.com> wrote:
Hi partners

Has anyone experience  this before?  I took this floor from 400 to 1800 & was very generous with the 5 X   I am getting a haze that looks like a white film. Any suggestions?






Best Regards




Www.Stonemakeover.com

Schubert E Jacques
973-879-3400

Best Regards


Powered by http://DiscussThis.com
Visit list archives, subscribe, unsubscribe or change your subscription preferences
Start a new conversation (thread)




--
Frederick M. Hueston PhD
www.stoneforensics.com
www.stoneandtilepros.com
Recommended stone care products  http://www.stonecarecentral.com

Many of my informational articles can be found at www.stoneandtilepros.com

Listen to my radio show at www.blogtalkradio.com/drfred
The Ultimate Stain Remover  www.GoDrFred.com

Cell 321-514-6845

Powered by http://DiscussThis.com
Visit list archives, subscribe, unsubscribe or change your subscription preferences
Start a new conversation (thread)