Used a black pad and some weight. It worked.

Sent via BlackBerry® from Telstra


From: Fred Hueston <fhueston@gmail.com>
Date: Fri, 8 Apr 2011 08:14:59 -0500
To: Restoration and Maintenance<sccpartners@stoneandtilepros.com>
ReplyTo: "Restoration and Maintenance" <sccpartners@stoneandtilepros.com>
Subject: RE: [sccpartners] Sealer film

you can try a honing powder. 

On Thu, Apr 7, 2011 at 4:58 PM, Mike Marsoun <nulifesc@bigpond.com> wrote:
Any ideas on the below?
------Original Message------
From: Mike Marsoun
To: Restoration and Maintenance
ReplyTo: Restoration and Maintenance
ReplyTo: Mike Marsoun
Subject: [sccpartners] Sealer film
Sent: Apr 7, 2011 10:51 AM

Looking at a job where someone mopped on a potassium siliconate sealer on ceramic tile and it left a residue (go figure). The tile is a monocoturra with a non slip texture, like a bead broadcast but it is in the glazing. I did a sample using a brown pad and an abrasive creme cleanser, and it came out fine, but it was a lot of work. Any ideas?
Sent via BlackBerry® from Telstra
--
Powered by http://DiscussThis.com
Visit list archives, subscribe, unsubscribe or change your subscription preferences:
http://www.discussthis.com/members/sccpartners@stoneandtilepros.com
Start a new conversation (thread): sccpartners@stoneandtilepros.com


Sent via BlackBerry® from Telstra
--
Powered by http://DiscussThis.com
Visit list archives, subscribe, unsubscribe or change your subscription preferences:
http://www.discussthis.com/members/sccpartners@stoneandtilepros.com
Start a new conversation (thread): sccpartners@stoneandtilepros.com




--
Frederick M. Hueston PhD
www.stoneforensics.com
www.stoneandtilepros.com
Recommended stone care products  http://www.stonecarecentral.com

Many of my informational articles can be found at www.stoneandtilepros.com

Listen to my radio show at www.blogtalkradio.com/drfred
The Ultimate Stain Remover  www.GoDrFred.com

Cell 321-514-6845


Powered by http://DiscussThis.com
Visit list archives, subscribe, unsubscribe or change your subscription preferences
Start a new conversation (thread)