I AGREE !!!!!!! IF YOU GRIND THIS FLOOR PLAN ON REPLACING IT. RUN DON’T , DON’T JUST WALK AWAY !!! HOPEFULLY FRED AND I MADE OURSELVES CLEAR ON THIS
John E. Freitag
The Stone and Tile School
NO NO NO DO NOT Grind it..you will ruin it..There is not a lot you can do other than to maybe put a coating on it that is non slippery.
On Sat, Apr 9, 2011 at 4:28 AM, stuart rosen <email@example.com> wrote:
I dont think grinding saltillo would work too well, Not to mention restaurant guys always seem to look for cheapest way. Why not clean and strip if needed then look into the coatings at richard james that you could make slip resistant.
On Fri, Apr 8, 2011 at 8:11 PM, <firstname.lastname@example.org> wrote:
A restaurant owner with a saltillo floor that is constantly slippery asked me if there was a way to clean it and flatten it in order to make it easier for them to keep clean.
I know that saltillo is mud, really, with a glaze but don't know if grinding it flat would be feasible and afterwards apply the coatings needed to protect it along with some abrasive or coarse shark grit type material to give the floor some traction.
Any thoughts or suggestions? Please share any feedback.
Sent from my BlackBerry® smartphone with Nextel Direct Connect
Powered by http://DiscussThis.com
Visit list archives, subscribe, unsubscribe or change your subscription preferences:
Start a new conversation (thread): email@example.com
Frederick M. Hueston PhD
Recommended stone care products http://www.stonecarecentral.com
Many of my informational articles can be found at www.stoneandtilepros.com
Listen to my radio show at www.blogtalkradio.com/drfred
The Ultimate Stain Remover www.GoDrFred.com