I have a customer who needs
 Scope of work: We are going to install photoluminescent aluminum strips on the leading edge of the steps. So the strips do not stick up above the step surface we need to grind a 2 mm deep x 1.5" wide slot along the entire length of each stair. Then the strips can be glued down into the slot and will be flush with the stair surface.
How do I make these cuts ?
Is this something that I should be interested in ?
How much can I charge for it ?
Paul Bunis
Xtremeclean Tile - Boston Stone Restoration
Specialty Stone Care

"Begin with the end in mind"