John is right on. Better to replace.

Sent via BlackBerry® from Telstra


From: "John Freitag" <jfreitag@thestoneandtileschool.com>
Date: Sat, 30 Jul 2011 10:40:09 -0400
To: Restoration and Maintenance<sccpartners@stoneandtilepros.com>
ReplyTo: "Restoration and Maintenance" <sccpartners@stoneandtilepros.com>
Subject: RE: [sccpartners] Tray line in Cafeteria

Paul,

 

More than likely the rails have been epoxy into the stone. when they were installed the fabricator probably cut a channel into the stone and then epoxy the  rails in. trying to remove these are probably next to impossible to do without damaging the stone. once the rails are remove then you will need to fill the channel and hopefully the stone has not chipped or had blow out when you remove the rail.

My recommended solution is to have the stone replaced. The risk and cost verses the end result ??

 

 

John E. Freitag

President/Director

The Stone and Tile School

Office 407-567-7652

Cell 407-615-0134

jfreitag@thestoneandtileschool.com

 

schoollogo

 

www.thestoneandtileschool.com

 

 

From: PBunis@aol.com [mailto:PBunis@aol.com]
Sent: Friday, July 29, 2011 3:32 PM
To: Restoration and Maintenance
Subject: [sccpartners] Tray line in Cafeteria

 

Bidding on a job where customer has metal rails on the tray lines in his cafe so that trays can slide across without damaging the stone. He tells me that customers hate these raised rails because when they put a drink down on the counter it falls over. (why they just don't put the cup between the rails I don't know....) but.....the rails need to be removed and the "slots" filled.

 Any suggestions on how to remove the rails without damaging the stone?????

 

Paul Bunis
Boston Stone Restoration
Absolute Chem Dry

781-793-0700
617-719-8454


"....begin with the end in mind."

 

In a message dated 7/29/2011 1:59:01 P.M. Eastern Daylight Time, jfreitag@thestoneandtileschool.com writes:

Adams

It depends upon the width of the grout line if the line is large than 1/8 inch you will need to use sanded grout. In order for the grout to match you may still need to used sanded grout regardless of the width of the grout lines

 

 

John E. Freitag

President/Director

The Stone and Tile School

Office 407-567-7652

Cell 407-615-0134

jfreitag@thestoneandtileschool.com

 

schoollogo

 

www.thestoneandtileschool.com

 

 

 

From: flooramor@aim.com [mailto:flooramor@aim.com]
Sent: Friday, July 29, 2011 1:34 PM
To: Restoration and Maintenance
Subject: RE: [sccpartners] Polishing crema marfil with black absolute

 

How wide is the grout joint?

Sent from a smartphone.


From: Info Info <info@restoreyourtiles.com>

Date: Fri, 29 Jul 2011 12:32:03 -0500

To: Restoration and Maintenance<sccpartners@stoneandtilepros.com>

ReplyTo: "Restoration and Maintenance" <sccpartners@stoneandtilepros.com>

Subject: RE: [sccpartners] Polishing crema marfil with black absolute

 

Thanks Fred.

 

To all,

I forgot to ask another question about the same floor: if some of the grout is missing and need to be repaired prior to honing, and originally installed grout was sanded (I know, who did that?), would you fix it with non sanded or sanded grout to match the texture and apperance of the rest of it.

 

Adam Bartos

BiO Tile

On Fri, Jul 29, 2011 at 7:42 AM, Fred Hueston <fhueston@gmail.com> wrote:

Mercotape.com

 

On Fri, Jul 29, 2011 at 8:24 AM, Fred Hueston <fhueston@gmail.com> wrote:

 Nashua 357. It is a 13 mil Ultra Duty Tape. from Merco Tape.

On Thu, Jul 28, 2011 at 10:05 PM, <info@restoreyourtiles.com> wrote:

I am looking for good plastic tape to protect black absolute during marble honing. I tried red tape from SCC but it seams that it loosing its grip when water gets to it. What do you guys use or do if you have granite mixed with marble (see picture).
Adam Bartos
BiO Tile

Sent via BlackBerry from T-Mobile
--
Powered by http://DiscussThis.com
Visit list archives, subscribe, unsubscribe or change your subscription preferences:
http://www.discussthis.com/members/sccpartners@stoneandtilepros.com
Start a new conversation (thread): sccpartners@stoneandtilepros.com




--
Frederick M. Hueston PhD
www.stoneforensics.com
www.stoneandtilepros.com
Recommended stone care products  http://www.stonecarecentral.com

Many of my articles can be found at www.stoneandtilepros.com

Listen to my radio show   www.blogtalkradio.com/drfred

office             321 514 6845      

See my specialty products at  www.godrfred.com

 





--
Frederick M. Hueston PhD
www.stoneforensics.com
www.stoneandtilepros.com
Recommended stone care products  http://www.stonecarecentral.com

Many of my articles can be found at www.stoneandtilepros.com

Listen to my radio show   www.blogtalkradio.com/drfred

office             321 514 6845      

See my specialty products at  www.godrfred.com

 


Powered by http://DiscussThis.com
Visit list archives, subscribe, unsubscribe or change your subscription preferences
Start a new conversation (thread)

 


Powered by http://DiscussThis.com
Visit list archives, subscribe, unsubscribe or change your subscription preferences
Start a new conversation (thread)


Powered by http://DiscussThis.com
Visit list archives, subscribe, unsubscribe or change your subscription preferences
Start a new conversation (thread)


Powered by http://DiscussThis.com
Visit list archives, subscribe, unsubscribe or change your subscription preferences
Start a new conversation (thread)

=


Powered by http://DiscussThis.com
Visit list archives, subscribe, unsubscribe or change your subscription preferences
Start a new conversation (thread)


Powered by http://DiscussThis.com
Visit list archives, subscribe, unsubscribe or change your subscription preferences
Start a new conversation (thread)