While you are grinding you can use acrylic mortar additive instead of water in a grit that you will be removing some material (80) and this will create a slurry that will harden in the pores and look the same as the concrete…because it is. This is part of the Husqvarna system, if you want to research it further.
From: flooramor@aim.com [mailto:flooramor@aim.com]
Sent: Thursday, September 08, 2011 1:50 AM
To: Restoration and Maintenance
Subject: RE: [sccpartners] Epoxy for Concrete?
Have you worked with Rapid Refloor?
Sent from a smartphone.
From: Baird Standish <bairdstandish@gmail.com>
Date: Wed, 7 Sep 2011 11:40:07 -0400
To: Restoration and Maintenance<sccpartners@stoneandtilepros.com>
ReplyTo: "Restoration and Maintenance" <sccpartners@stoneandtilepros.com>
Subject: [sccpartners] Epoxy for Concrete?
Hi,
We have a concrete floor that we just polished and there are a few shallow holes/spalls that I patched with a very strong concrete polymer epoxy.? The stuff is bullet proof but unfortunately turns to a tobacco colored patch.? Was wondering if anyone has sucessfully used a clear epoxy like bonstone or other natural stone epoxies to repair the concrete patch.? I don't think the patches have to be bulletproof, but I would like them to blend into the surround grey concrete as much as possible.? Any suggestions?
Thanks much.
Baird
--
________________________________________
From the desk of
Baird Standish
Managing Partner
Facility Specialists, LLC
1616 Walnut St.
Philadelphia, PA 19103
Phone: 215-732-7505
Fax: 215-546-9160
Powered by http://DiscussThis.com
Visit list archives, subscribe, unsubscribe or change your subscription preferences
Start a new conversation (thread)
Powered by http://DiscussThis.com
Visit list archives, subscribe, unsubscribe or change your subscription preferences
Start a new conversation (thread)No virus found in this incoming message.
Checked by AVG - www.avg.com
Version: 9.0.901 / Virus Database: 271.1.1/3877 - Release Date: 09/07/11 04:44:00
