thats what I would use, a clear epoxy.

On Tue, Sep 13, 2011 at 7:16 AM, Mike Marsoun <nulifesc@bigpond.com> wrote:
I will be doing this job where the pictured greek marble will be used. It is very dense. There are chips on a lot of the edges and corners. They want it all removed by grinding but I told them I would need to patch the bigger chips, not going to be committed to grind so deep... It is exterior, so I need an epoxy rather than a polyester. Any suggestions for the glue? The chips are so small I was thinking about using the epoxy clear.
Sent via BlackBerry® from Telstra
--
Powered by http://DiscussThis.com
Visit list archives, subscribe, unsubscribe or change your subscription preferences:
http://www.discussthis.com/members/sccpartners@stoneandtilepros.com
Start a new conversation (thread): sccpartners@stoneandtilepros.com




--
Frederick M. Hueston PhD
www.stoneforensics.com
www.stoneandtilepros.com
Recommended stone care products  http://www.stonecarecentral.com

Many of my articles can be found at www.stoneandtilepros.com
Listen to my radio show   www.blogtalkradio.com/drfred
office             321 514 6845      
See my specialty products at  www.godrfred.com