Tenax makes a water clear flowing 2 part epoxy.--
On Tue, Sep 13, 2011 at 7:08 AM, Mike Marsoun <nulifesc@bigpond.com> wrote:
Fred can you recommend a brand?
From: Fred Hueston [mailto:fhueston@gmail.com]
Sent: Tuesday, September 13, 2011 10:05 PM
To: Restoration and Maintenance
Subject: RE: [sccpartners] Chip patching
thats what I would use, a clear epoxy.
On Tue, Sep 13, 2011 at 7:16 AM, Mike Marsoun <nulifesc@bigpond.com> wrote:
I will be doing this job where the pictured greek marble will be used. It is very dense. There are chips on a lot of the edges and corners. They want it all removed by grinding but I told them I would need to patch the bigger chips, not going to be committed to grind so deep... It is exterior, so I need an epoxy rather than a polyester. Any suggestions for the glue? The chips are so small I was thinking about using the epoxy clear.
Sent via BlackBerry® from Telstra
--
Powered by http://DiscussThis.com
Visit list archives, subscribe, unsubscribe or change your subscription preferences:
http://www.discussthis.com/members/sccpartners@stoneandtilepros.com
Start a new conversation (thread): sccpartners@stoneandtilepros.com
--
Frederick M. Hueston PhD
www.stoneforensics.com
www.stoneandtilepros.com
Recommended stone care products http://www.stonecarecentral.comMany of my articles can be found at www.stoneandtilepros.com
Listen to my radio show www.blogtalkradio.com/drfred
office 321 514 6845
See my specialty products at www.godrfred.com
Powered by http://DiscussThis.com
Visit list archives, subscribe, unsubscribe or change your subscription preferences
Start a new conversation (thread)No virus found in this incoming message.
Checked by AVG - www.avg.com
Version: 9.0.914 / Virus Database: 271.1.1/3877 - Release Date: 09/13/11 04:35:00
WORLD CLASS STONECARE PRODUCTS