Alex
We do alot of carrara tops in our area. Occasionally we run into a sensitive one.
Unless the customer used massive amounts of cyrstalizer you should be fine starting with 220 g resin and taking up to maybe 800 or so. If you need to start deeper use 220 g sandpaper flat then start 220 resins. If you have time a.d want to run your diamonds higher why not but you will be fine ending at 800.
The crux is the polishing use less water in whichever polish you use. Also start with half the amount. Of powder you normally use and adjust from there.
Try and use an amount of powder that you think wouldn't work and you should be fine.
Like steve said but hone it to 3000 and your polishing powder will not have to do too much. Orange peel is from over polishing needed to close the pores and achieve the polish when the diamond honing is not sufficient. Close the pores with diamonds then lightly polish.
From: stephen@newlifemarblerestoration.com [mailto:stephen@newlifemarblerestoration.com]
Sent: Saturday, March 17, 2012 12:57 PM
To: Restoration and Maintenance
Subject: RE: [sccpartners] White carerra marble vanity
I would try honing up to good clarity then use MB12 almost completely dry. water will over react the acid and cause orange peel. Aloha
----- Original Message -----
From: Alex Rivera
Sent: Friday, March 16, 2012 2:35 PM
Subject: RE: [sccpartners] White carerra marble vanity
Hi Randy,
Have you had this situation before? How deep do you suggest?
Kind Regards,
Alex Rivera
On Fri, Mar 16, 2012 at 8:07 PM, Randy Frye <rfrye@comcast.net> wrote:
Maybe cut the surface a little deeper then bring it up.
On Mar 16, 2012, at 6:44 PM, Alex Rivera wrote:
New white carerra marble with smooth glass like finish from factory. Clients housekeeper etched it. Client tried crystallizing it themselves. We were called after they attempted to fix it themselves.
I have tried a variety of methods to repair but keep having an orange peeling issue.
Tried tin oxide. Tried mixing tin oxide with marble powder.
After honing, is it possible to bring it back to the factory glass gloss?
I have worked on much white carerra marble before and it never behaved like this.
Thanks in advance for your tips and opinions.
Alex Rivera
Powered by http://DiscussThis.com
Visit list archives, subscribe, unsubscribe or change your subscription preferences
Start a new conversation (thread)
Powered by http://DiscussThis.com
Visit list archives, subscribe, unsubscribe or change your subscription preferences
Start a new conversation (thread)No virus found in this message.
Checked by AVG - www.avg.com
Version: 2012.0.1913 / Virus Database: 2114/4874 - Release Date: 03/16/12Powered by http://DiscussThis.com
Visit list archives, subscribe, unsubscribe or change your subscription preferences
Start a new conversation (thread)No virus found in this incoming message.
Checked by AVG - www.avg.com
Version: 9.0.927 / Virus Database: 271.1.1/4275 - Release Date: 03/17/12 05:34:00
Powered by http://DiscussThis.com
Visit list archives, subscribe, unsubscribe or change your subscription preferences
Start a new conversation (thread)