Baird,
From the pictures I don’t think this is a sealer issue. I feel
it a honing issue. From the pictures it appears you honed up to and within 3 to
4 inches of the edge, were these areas hand honed?
It appears you are leaving this floor at a low honed finish and
the edges still have the original finish left on the stone. As I look at these
pictures you can see where the honing was as the scratches for the honing with
a floor machine has never been blended into the edges.
Regarding the linseed oil and mineral spirits if anyone uses
this mixture be careful as to how you handle the applicator after you finish
the job, just don’t throw this in you truck. Linseed oil has a low very
low flash point and unless you soak the applicator in water with some type cleaner
you can run a HIGH RISK of catching a truck , your warehouse or wherever this
applicator end up on FIRE !!!
I know of several people including myself early on in my stone career
that have burnt up trucks. CAUTION CAUTION when using this mixture.
So Baird I would recommend you go back and do some hand work
with diamonds and I think you will see these edges blend in.
John E Freitag
Director
The
Stone & Tile School
Office
407-567-7652
Cell
407-615-0134
jfreitag@thestoneandtileschool.com
www.thestoneandtileschool.com
From: Baird Standish
[mailto:bairdstandish@gmail.com]
Sent: Thursday, March 29, 2012 3:51 PM
To: Restoration and Maintenance
Subject: [sccpartners] Edge issues-light and dark
Hi,
We finally got through our large limestone grinding/honing
project and it came out pretty well. On thing we need to take care of in
a few areas are in some corners and along some edges. We are trying to get the
edges to be relatively consistent colorwise with the rest of the floor.
In some areas, the limestone is whiting out and in others the edges are
very dark where we didn't grind and hone up to the edge, or where the
color-enhancing impregnating sealer pooled a little more than we wanted and created
some darker areas. Was wondering if there is a sealer that will perhaps
bring up the color without being so dark. I am finding that the edges are
sort of over reacting to the impregnating sealer and the stuff is really hard
to control in those areas. Perhaps a wax? We are finishing to a honed
finish, not a high gloss. I have two pictures below. One picture
shows where the light and dark are right next to each other.
Thanks,
Baird
--
PLEASE NOTE OUR NEW ADDRESS AND PHONE NUMBERS. THE OLD NUMBERS WILL WORK
FOR SOME PERIOD OF TIME.
________________________________________
>From the desk of
Baird Standish
Managing Partner
Facility Specialists, LLC
15 West Highland Ave.
Philadelphia, PA 191118
Phone: 267-331-5369
Fax: 267-331-5771
Powered by http://DiscussThis.com
Visit
list archives, subscribe, unsubscribe or change your subscription preferences
Start a new conversation
(thread)