Are you doing this using a walk behind scrubber or a swing machine.
I would recommend you do this size job using a walk behind scrubber to diamond hone with.
The additional time will depend upon the type of machine you are using and the size of the machine and if you are using a walk behind scrubber
John E Freitag
Director
The Stone & Tile School
Office 407-567-7652
Cell 407-615-0134
jfreitag@thestoneandtileschool.com
From: amondor@a1cement.com [mailto:amondor@a1cement.com]
Sent: Monday, May 14, 2012 12:57 PM
To: Restoration and Maintenance
Subject: RE: [sccpartners] Pure white quartz
Thanks
Howmuch more time on the floor than say a normal carrera for a job like this
Do u0think
ASent on the TELUS Mobility network with BlackBerry
From: "John Freitag" <jfreitag@thestoneandtileschool.com>
Date: Mon, 14 May 2012 11:38:07 -0400
To: Restoration and Maintenance<sccpartners@stoneandtilepros.com>
ReplyTo: "Restoration and Maintenance" <sccpartners@stoneandtilepros.com>
Subject: RE: [sccpartners] Pure white quartz
Armand,
The mechanical polish id going to give you the shine, however I think to get the glossy shine you may need to hone up to a 5500 or 8500
Once you cut the floor flat you should not have any problems with the scratches on the edges. Make sure your first grind the floor is totally flat. If the floor is not totally flat then you could have a problem the scratches on the edges.
John E Freitag
Director
The Stone & Tile School
Office 407-567-7652
Cell 407-615-0134
jfreitag@thestoneandtileschool.com
From: Armand Mondor [mailto:AMondor@a1cement.com]
Sent: Monday, May 14, 2012 10:14 AM
To: Restoration and Maintenance
Subject: [sccpartners] Pure white quartz
Hi Guys
I have been asked to grind flat, hone & polish 14,000 Sq. Feet of quartz tile that is the whitest and shiniest I have ever seen.
The owner has received the 12X24 tiles and is going to have them installed in his high end shopping mall.
The tile setter has found thickness inconsistencies and has determined the best solution is to flatten in place and re polish.
I have some sample tiles and am going to do a shop floor mock up on a piece of plywood but before beginning would appreciate you input.
I have worked on a similar textured and grainy tile – a sort of pink which apparently came from India. My biggest problem with that stuff was that it
showed edge scratching worse than anything I’d seen b4.
Intend to do a complete mechanical diamond resin pad grind,hone polish all the way to 3000 to try to duplicate factory shine without reliance on
any finishing powders.
Would appreciate your input
Thank You:
Armand
Powered by http://DiscussThis.com
Visit list archives, subscribe, unsubscribe or change your subscription preferences
Start a new conversation (thread)
Powered by http://DiscussThis.com
Visit list archives, subscribe, unsubscribe or change your subscription preferences
Start a new conversation (thread)
Powered by http://DiscussThis.com
Visit list archives, subscribe, unsubscribe or change your subscription preferences
Start a new conversation (thread)
