On May 14, 2012 5:19 PM, "Adam" <info@restoreyourtiles.com> wrote:

John. Would rsr-2000 work?

Adam Bartos
BiO Tile & Grout Restoration
773-575-5515 (c)
847-438-0212 (o)
www.RestoreYourTiles.com

On May 14, 2012, at 3:47 PM, "John Freitag" <jfreitag@thestoneandtileschool.com> wrote:

> Adam,
>
> First it appears that water is getting under the stone and thus causing the
> stone to oxide. I would first try to determine where the moisture is getting
> under the stone and allow the stone to dry, perhaps even place a
> dehumidifier in the area to assist in drying the floor. then apply a
> poultice to remove the iron stains.,
>
> I would open the floor with a 120 diamond to assist in the drying and then
> apply the poultice using iron out. This may take several application to
> remove.
>
> Unless you stop the moisture from getting into the stone the oxidation is
> going to occur again.  Be sure to seal after you remove all the stains.
>
> Also the iron out is going to etch the stone so you will need to refinish
> the stone.
>
>
> John E Freitag
> Director
> The Stone & Tile School
> Office 407-567-7652
> Cell 407-615-0134
> jfreitag@thestoneandtileschool.com
>
>
>
> www.thestoneandtileschool.com
>
>
>
> -----Original Message-----
> From: Adam [mailto:info@restoreyourtiles.com]
> Sent: Monday, May 14, 2012 11:33 AM
> To: Restoration and Maintenance
> Subject: [sccpartners] Limestone problem
>
>
>
>
>
>
> --
> Powered by http://DiscussThis.com
> Visit list archives, subscribe, unsubscribe or change your subscription preferences:
> http://www.discussthis.com/members/sccpartners@stoneandtilepros.com
> Start a new conversation (thread): sccpartners@stoneandtilepros.com
>
>
>

--
Powered by http://DiscussThis.com
Visit list archives, subscribe, unsubscribe or change your subscription preferences:
http://www.discussthis.com/members/sccpartners@stoneandtilepros.com
Start a new conversation (thread): sccpartners@stoneandtilepros.com