Freddie,
I just saw this picture for some reason it ended up in my junk
mail.
I would use honing powders and oxi- clean on this floor. I would
first use an alkaline based stripper to help clean the holes ,if you have a
pressure cleaning system I would use that at 800 to 900 PSI this will clean the
stone nice and then use the honing powders and the oxi – clean you should end
up with a nice finish.
John E Freitag
Director
The
Stone & Tile School
Office
407-567-7652
Cell
407-615-0134
jfreitag@thestoneandtileschool.com
www.thestoneandtileschool.com
From: Freddie DeJesus
[mailto:info@eliteflooringandrefinishing.com]
Sent: Thursday, June 14, 2012 9:44 PM
To: Restoration and Maintenance
Subject: [sccpartners] Hone and polish
Hi partners,
I want to hone and polish this floor. It dosnt have a flat finish and the
marble is rounded at the edges. Can I hone with resin diamonds the same as I
would with flat finish? There are scraches and etch marks that need to come out.
Any advice would be greatly appreciated. Thanks
Powered by http://DiscussThis.com
Visit
list archives, subscribe, unsubscribe or change your subscription preferences
Start a new conversation
(thread)