Freddie,
I just saw this picture for some reason it ended up in my junk mail.
I would use honing powders and oxi- clean on this floor. I would first use an alkaline based stripper to help clean the holes ,if you have a pressure cleaning system I would use that at 800 to 900 PSI this will clean the stone nice and then use the honing powders and the oxi – clean you should end up with a nice finish.
John E Freitag
Director
The Stone & Tile School
Office 407-567-7652
Cell 407-615-0134
jfreitag@thestoneandtileschool.com
From: Freddie DeJesus [mailto:info@eliteflooringandrefinishing.com]
Sent: Thursday, June 14, 2012 9:44 PM
To: Restoration and Maintenance
Subject: [sccpartners] Hone and polish
Hi partners,
I want to hone and polish this floor. It dosnt have a flat finish and the marble is rounded at the edges. Can I hone with resin diamonds the same as I would with flat finish? There are scraches and etch marks that need to come out. Any advice would be greatly appreciated. Thanks
Powered by http://DiscussThis.com
Visit list archives, subscribe, unsubscribe or change your subscription preferences
Start a new conversation (thread)
Powered by http://DiscussThis.com
Visit list archives, subscribe, unsubscribe or change your subscription preferences
Start a new conversation (thread)
