sure looks like vein cut travertine to me vs the cross cut you usually see. i would say a tin oxide would do it if 5x wont.
From: Nicinski <mail@rocklandstonerestoration.com>
To: Stone and Tile PROS Technical Support <sccpartners@stoneandtilepros.com>
Sent: Tuesday, August 14, 2012 9:17 AM
Subject: RE: [sccpartners] Photos
Kevin if you have dry diamond pads put them on your makita and try to go dry last 3 steps with higher speed like 2.5 - 3 on the dialer seting
--
Regards,
Rockland Stone Restoration
845-323-7333
www.rocklandstonerestoration.com
On Tue, Aug 14, 2012 at 8:53 AM, John Freitag <jfreitag@thestoneandtileschool.com> wrote:
Kevin,I cannot tell much from these pictures, but if the stone is not reacting to 5x then I would try to polish it like granite using the the white granite polishing powders.John E FreitagDirectorThe Stone & Tile SchoolOffice 407-567-7652Cell 407-615-0134From: N-Motion Stone and Tile Care [mailto:klhudson@atlantastoneandtilecare.com]
Sent: Friday, August 10, 2012 12:07 PM
To: Stone and Tile PROS Technical Support
Subject: [sccpartners] PhotosHere are the photos!
Sent from my iPhone
Begin forwarded message:From: "K. Hudson" <klhudson16@comcast.net>
Date: August 10, 2012 12:01:52 PM EDT
To: klhudson@atlantastoneandtilecare.com
Subject: Fwd: Stone idPowered by http://www.discussthis.com
Visit list archives, subscribe, unsubscribe or change your subscription preferences
Start a new conversation (thread)
--
Regards,
Rockland Stone Restoration
845-323-7333
www.rocklandstonerestoration.com