I would just brush it again if it is brush honed. 

Sent from my iPhone

On 17/12/2012, at 2:03 AM, Fred Hueston <fhueston@gmail.com> wrote:

If its not a polished finish than a honing powder may work

On Sat, Dec 15, 2012 at 11:36 AM, Freddie DeJesus <info@eliteflooringandrefinishing.com> wrote:
Hi Partners,
I have a builder that has a floor that is a Turkish marble that has a 4 piece, jumbo size, brushed finish floor, that has been etched.
What in your opinion is the best way to remove the etching?

--
Wilfredo DeJesus
Elite Flooring Inc.


Powered by http://DiscussThis.com
Visit list archives, subscribe, unsubscribe or change your subscription preferences
Start a new conversation (thread)




--
Frederick M. Hueston PhD
www.stoneforensics.com
www.stoneandtilepros.com
www.safeandcompliant.net

Recommended stone care products  http://www.stonecarecentral.com

Many of my articles can be found at www.stoneandtilepros.com
Listen to my radio show   www.blogtalkradio.com/drfred
office             321 514 6845      
See my specialty products at  www.godrfred.com


Powered by http://DiscussThis.com
Visit list archives, subscribe, unsubscribe or change your subscription preferences
Start a new conversation (thread)