You can grind the porcelain then refinish.

I have never done it and probably wouldnt.

Porcelain is very hard on the diamonds and takes a long time to cut.

I have heard it is nightmarish.

I dont think you could fill the grooves.

 

On Fri, Aug 23, 2013 at 1:29 PM, Baird Standish <bairdstandish@gmail.com> wrote:

Hi. I am looking at a job where porcelain tiles have been deeply scarred by a rotating machine used to take off tile mastic. These are those small round mosaic tiles set into a black matrix. The scratch patterns are such that, if this were marble, it would require metal diamonds. I was wondering if anyone has had success with filling the scarring with a white or clear epoxy or something similar. Maybe even color seal. Applied and the excess taken of with razor blades. This is assuming the scratches cannot be ground off and the tile polished. Thanks
B

--

________________________________________
From the desk of
Baird Standish
Managing Partner
Facility Specialists, LLC
15 West Highland Ave.
Suite E
Philadelphia, PA 19118
Phone: 215-732-7505
Fax: 215-546-9160
www.facspecs.com

---

Powered by http://DiscussThis.com
Visit list archives, subscribe, unsubscribe or change your subscription preferences
Start a new conversation (thread)

--

Regards,
Stu Rosen
201-446-1200
www.mbstonecare.com 

www.mbstone.com

www.mbstonepro.com
www.stoneshine.com
"EVERYTHING MATTERS "

 

---

Powered by http://DiscussThis.com
Visit list archives, subscribe, unsubscribe or change your subscription preferences
Start a new conversation (thread)