Hi.  I have a client who has asked if we would remove the gloss from an office lobby floor, leaving the floor with a completely non glossy flat honed finish.  It is a Tennessee marble. We actually did work on a floor in this building a year ago and rendered a low gloss sheen, which came out very well. We cut the floor with diamonds from 50 up to 200 and then used a combination of 5x and honing powder.  In this case I would probably do the same thing and go with just a low grit honing powder.  I also believe this floor was crystallized.  Was wondering if anyone else has had a request like this and has a good approach (what diamonds to finish with, what grit honing powder etc.?)  Thanks so much. 

B

________________________________________
From the desk of
Baird Standish
Managing Partner
Facility Specialists, LLC
15 West Highland Ave.
Suite E
Philadelphia, PA 19118
Phone: 215-732-7505
Fax: 215-546-9160
www.facspecs.com

GH

---

Powered by http://DiscussThis.com
Visit list archives, subscribe, unsubscribe or change your subscription preferences
Start a new conversation (thread)