Thanks John. I think I have the general idea. If you don't mind, I may want to touch base with you when I get closer to zero hour. 
B


________________________________________
From the desk of
Baird Standish
Managing Partner
Facility Specialists, LLC
15 West Highland Ave. Suite E
Philadelphia, PA 19118
Phone: 215-732-7505
Fax: 215-546-9160
www.facspecs.com

On Jan 30, 2014, at 7:34 PM, john jackson <kcstoneguy@yahoo.com> wrote:

yeah I slice a horizontal slot and epoxy in a stainless steel rod I get at home depot. I wrap the repair with duct tape and pack the rapidest in it, the tape keeps it from running out..it will set up in 10 minutes. for the white veins I usually paint that in with an artist brush and spread with a razor blade..let it set up then I sand with 40 grit sand paper..i never run the steps on the diamond pads,just try to match the rest of the marble..im doing a repair on Jerusalem stone myself next week the same way..if you try to make this whole repair with epoxy it ususally cracks
 


On Thursday, January 30, 2014 4:21 PM, Baird Standish <bairdstandish@gmail.com> wrote:
Hi John. That seems like a good and probably only solution. Would you place the rods horizontally across or gave them sticking up vertically from the bottom?  I was thinking about fashioning a sort of cage, but maybe that's too complicated b

Sent from Mailbox for iPhone


On Thu, Jan 30, 2014 at 6:13 PM, john jackson <kcstoneguy@yahoo.com> wrote:
that's rosso levanto...good luck finding any...if you can you could make straight cut and insert a 2 cm piece then grind and shape it once in place....probably wont work if this is something to be walked on like a step...what we do on terrazzo and white marble is rod the repair then wrap it in rapid set repair mortar which makes it really solid, then just do like skim coat with the epoxy..you are looking at purple with with veins


On Thursday, January 30, 2014 1:06 PM, Baird Standish <bairdstandish@gmail.com> wrote:
Hi.  I have a large chip in a marble step on a church alter where the bullnose would need to be refashioned.  I am wondering, instead of just pouring epoxy into the chip and fashioning it with a putty knife, etc, If there is a better way, such as taking a mold of the bullnose and/or the entire chip and fashioning a piece that would more or less fit into the chip.  Thanks,
Baird

________________________________________
From the desk of
Baird Standish
Managing Partner
Facility Specialists, LLC
15 West Highland Ave.
Suite E
Philadelphia, PA 19118
Phone: 215-732-7505
Fax: 215-546-9160
http://www.facspecs.com/






Powered by http://DiscussThis.com
Visit list archives, subscribe, unsubscribe or change your subscription preferences
Start a new conversation (thread)