The tile from the surface is drinking so try a humid test and see if its full of humidity, if it is then simply a seal the stone and it may eventually get back its original color
From: Roger Konarski [mailto:qm144@yahoo.com]
Sent: May-12-09 11:24 PM
To: Restoration and Maintenance
Subject: RE: [sccpartners] Shower Problem
It was kind of my thoughts it is some thing coming from behind the stone! It would seem cutting with 120 should have taken me below the problem!
--- On Tue, 5/12/09, Mike Marsoun <nulifesc@bigpond.com> wrote:
From: Mike Marsoun <nulifesc@bigpond.com>
Subject: RE: [sccpartners] Shower Problem
To: "Restoration and Maintenance" <sccpartners@stoneandtilepros.com>
Date: Tuesday, May 12, 2009, 10:18 PMIts most likley internal rust caused from moisture wicking up from the shower pan mortar.
Sent via BlackBerry® from Telstra
From: Roger Konarski
Date: Tue, 12 May 2009 19:50:36 -0700 (PDT)
To: Restoration and Maintenance<sccpartners@stoneandtilepros.com>
Subject: [sccpartners] Shower Problem
I’m working on a travertine shower. The issue is that the tiles below the marble border are darker the tiles above the border. I cut it with 120 sand papers and it did lighten the stone, but it still does not match the upper section. I’m hesitant to keep cutting due to concern that I will open up a lot of holes. My other thoughts are to poultice the lower section with hydrogen peroxide, but that could possible involve number of trips to the job.
Any suggestions appreciated!
Please see attached pictures. I took the picture will the stone is wet so they are darker than when dry.
Powered by http://DiscussThis.com
Visit list archives, subscribe, unsubscribe or change your subscription preferences
Start a new conversation (thread)
Powered by http://DiscussThis.com
Visit list archives, subscribe, unsubscribe or change your subscription preferences
Start a new conversation (thread)