Roger
this can happen when you aren't use to crystalizing.
It isn't a big deal-just send a good tech back with more crystallizer and steel wool .
They will need to buff out the swirls using a mist of crystallizer.
if you have #1 steel wool that may help.


On Wed, May 21, 2014 at 9:36 AM, Randy Frye <rfrye@comcast.net> wrote:
We always dry buff it with a clean steel wool once the  crystalizing process is finished.


On May 21, 2014, at 9:15 AM, Roger Konarski (via sccpartners list) <nobody@simplelists.com> wrote:

This email was sent from yahoo.com which does not allow forwarding of emails via email lists. Therefore the sender's email address (qm144@yahoo.com) has been replaced with a dummy one.

My techs did a commercial job with black marble. The final strep way to crystalize the floor. I just got a call back with issues of swirl marks. They use 0 steel wool. We very rarely crystalize , thus have very little experience in that area.
What did we do wrong and needs to de done to correct the problem?

Thanks,

Roger  
 
Visit list archives, subscribe, unsubscribe or change your subscription 
preferences:
http://stoneandtilepros.simplelists.com/sccpartners
 
Start a new conversation (thread): 
sccpartners@stoneandtilepros.simplelists.com


 
Visit list archives, subscribe, unsubscribe or change your subscription 
preferences:
http://stoneandtilepros.simplelists.com/sccpartners
 
Start a new conversation (thread): 
sccpartners@stoneandtilepros.simplelists.com




--
Regards,
Stu Rosen
201-446-1200
www.stoneshine.com
www.mbstonecare.com
www.mbstonepro.com
"EVERYTHING MATTERS"