It is a little precarious because in relying on an enhancer it needs to be relatively uniform before application or the problem remains.  

Sent from my iPhone

On 13 Jun 2014, at 6:14 am, bairdstandish@gmail.com wrote:

I have been running into these coated granites more often than not these days. A real problem. Have used Pectro a few times with good results but it doesn't always work. Pectro comes in Black and clear and is for micro-fissuring/spiderwebbing I these coatings. 
B

Sent from Mailbox


On Thu, Jun 12, 2014 at 12:07 AM, Mike Marsoun <nulifesc@bigpond.com> wrote:

Thanks guys. I found the Miricle sealants seal and enhance goes off hard too bit you can't get it here. 

Sent from my iPhone

On 12 Jun 2014, at 12:23 pm, Gregory Cook <info@surfaceshawaii.com> wrote:

Honing powders or an 800 grit diamond impregnated pad will work best. Akemi enhancer will work great to put back down because it will cure hard and not leave a greasy film on the granite, especially since it is a slope. If they want it darker akemi also makes the enhancer plus ink. 

Thank You,
Gregory Cook
Surface Solutions Inc. 
808.891.1963

Sent from my iPhone

On Jun 11, 2014, at 3:53 PM, "Roger Konarski (via sccpartners list)" <nobody@simplelists.com> wrote:

This email was sent from yahoo.com which does not allow forwarding of emails via email lists. Therefore the sender's email address (qm144@yahoo.com) has been replaced with a dummy one.

The stone is fine, it is the color enhancer sealer that has reacted with the wine. 180 grit honing powders with clean it up. Pre wet the grout lines 1st to try avoid lightening up the grout. Reapply a sealer can be some what of a problem.  It may not take a sealer and the sealer is on top leaving streak marks.  We usually take a micro fiber rag and wipe it on. Also set the customer expectations that black honed granite is actually a slight grayish color. The stuff they put on the granite to make it black is what is causing the problem.


On Wednesday, June 11, 2014 8:04 PM, N-Motion Stone and Tile Care <klhudson@atlantastoneandtilecare.com> wrote:


Mike,
I would try stripping it with alkaline base stripper and apply color enhancer!



Sent from my iPhone
Kevin L. Hudson
N-Motion Stone and Tile
(678) 662-0110
> On Jun 11, 2014, at 8:23 PM, Mike Marsoun <nulifesc@bigpond.com> wrote:
>
> This is a "honed black granite" ramp that had a bottle of white wine spilled on it and ran down. They said it was etched. What would you do? 
>
>
> Visit list archives, subscribe, unsubscribe or change your subscription
> preferences:
> http://stoneandtilepros.simplelists.com/sccpartners
>
> Start a new conversation (thread):
> sccpartners@stoneandtilepros.simplelists.com
>
> <IMG_0243.JPG>
>
>
>
> Sent from my iPhone


Visit list archives, subscribe, unsubscribe or change your subscription
preferences:
http://stoneandtilepros.simplelists.com/sccpartners

Start a new conversation (thread):
sccpartners@stoneandtilepros.simplelists.com


 
Visit list archives, subscribe, unsubscribe or change your subscription 
preferences:
http://stoneandtilepros.simplelists.com/sccpartners
 
Start a new conversation (thread): 
sccpartners@stoneandtilepros.simplelists.com

 
Visit list archives, subscribe, unsubscribe or change your subscription 
preferences:
http://stoneandtilepros.simplelists.com/sccpartners
 
Start a new conversation (thread): 
sccpartners@stoneandtilepros.simplelists.com

 
Visit list archives, subscribe, unsubscribe or change your subscription 
preferences:
http://stoneandtilepros.simplelists.com/sccpartners
 
Start a new conversation (thread): 
sccpartners@stoneandtilepros.simplelists.com


 
Visit list archives, subscribe, unsubscribe or change your subscription 
preferences:
http://stoneandtilepros.simplelists.com/sccpartners
 
Start a new conversation (thread): 
sccpartners@stoneandtilepros.simplelists.com