You arte right, he did treat the edges with an enhancer. Does anyone recall the solvent the Fred recommended to remove an enhancer?
Thanks,
Roger
On Saturday, September 27, 2014 2:15 PM, Stephen Webb <stephen@newlifemarblerestoration.com> wrote:
Maybe the fabricators treated the edges with something that has
soaked in, Where the stove cutout, being rough cut and most opened
pored has drawn in the treatment deepest
Maybe it's enhancer or a wax?
Maybe it's enhancer or a wax?
On 9/26/2014 6:45 PM, Roger Konarski
(via sccpartners list) wrote:
This email was sent from yahoo.com which does not allow forwarding of emails via email lists. Therefore the sender's email address (qm144@yahoo.com) has been replaced with a dummy one.
I was sent this video of a quartzite top. Around the edges the stone is getting dark. The question, what is causing the problem and is there a remedy? The stone was sealed with dry treat?Thanks for your help !
Visit list archives, subscribe, unsubscribe or change your subscription preferences: http://stoneandtilepros.simplelists.com/sccpartners Start a new conversation (thread): sccpartners@stoneandtilepros.simplelists.com
|
|
This email is free from viruses and malware because avast! Antivirus protection is active.
|
Visit list archives, subscribe, unsubscribe or change your subscription preferences: http://stoneandtilepros.simplelists.com/sccpartners Start a new conversation (thread): sccpartners@stoneandtilepros.simplelists.com