I think the general consensus for grout to cure is 7 days.

However polyblend says there grout cures in 24 hours.

I think you can hone it after a few days .

As far as knocking off the polish use vortex pads to start.

Use.a 220 red dot vortex pads to start.

You will need to get the edges nd any picture frames .

Place a white pad between the vortex and pad driver.

Finish with another vortex pad or any way you normally do.

On Mar 4, 2015, at 3:00 PM, Roger Konarski (via sccpartners list) <nobody@simplelists.com> wrote:

This email was sent from yahoo.com which does not allow forwarding of emails via email lists. Therefore the sender's email address (qm144@yahoo.com) has been replaced with a dummy one.

I have a job to restore a newly installed polish marble floor to a honed finish. It was grout today , Wednesday 03.04.15. When will it be safe to start honing the floor?

Also any tips on knocking down the gloss besides using diamonds and honing powder.

Thanks,

Roger

Visit list archives, subscribe, unsubscribe or change your subscription preferences: http://stoneandtilepros.simplelists.com/sccpartners Start a new conversation (thread): sccpartners@stoneandtilepros.simplelists.com