What about a light mist of muratic acid to etch the stone. This eliminates all picture framing. Following with a neutralizer and the pads mentioned previously. The acid application is effective on counters also and honing powders or spinergy pads can produce a smooth even finish.

On Mar 4, 2015 6:04 PM, "Roger Konarski (via sccpartners list)" <nobody@simplelists.com> wrote:

This email was sent from yahoo.com which does not allow forwarding of emails via email lists. Therefore the sender's email address (qm144@yahoo.com) has been replaced with a dummy one.

I have a job to restore a newly installed polish marble floor to a honed finish. It was grout today , Wednesday 03.04.15. When will it be safe to start honing the floor?
Also any tips on knocking down the gloss besides using diamonds and honing powder.

Thanks,

Roger
Visit list archives, subscribe, unsubscribe or change your subscription preferences: http://stoneandtilepros.simplelists.com/sccpartners Start a new conversation (thread): sccpartners@stoneandtilepros.simplelists.com