Just try a high alkaline cleaner and it will emulsify the WD40.

Then just blot it up.

You will need to do it a few times.

If it is real soapstone it has no porosity .

The oil is sitting in the face of the stone.

Think of the surface as a microscopic English muffin.

Just clean out those nooks and crannies

Sent from my iPhone

On May 17, 2015, at 2:39 PM, "Roger Konarski (via sccpartners list)" <nobody@simplelists.com> wrote:

This email was sent from yahoo.com which does not allow forwarding of emails via email lists. Therefore the sender's email address (qm144@yahoo.com) has been replaced with a dummy one.

Cost got WD 40 on soap stone / now it is stained. My recommendation would to us mineral spirits and paper towels. Are their any potential issue with trying to remove stains from soap stone?

Thanks,

Roger

Visit list archives, subscribe, unsubscribe or change your subscription preferences: http://stoneandtilepros.simplelists.com/sccpartners Start a new conversation (thread): sccpartners@stoneandtilepros.simplelists.com