Start with a 100 resin and clean up. Look to see if that removed it. If it didn't go deeper 50 resin or 100 electroplate and check it again. Careful not to bowl it out. Once removed take it back up grits and polish if needed. Good luck

Best Regards,

Randy Frye, CEI Surface Pros

239-253-1991

On Oct 26, 2016, at 11:50 AM, Richard Middleton <richard@prosteem.com> wrote:

Partner’s I have this customer with bad etch spot on vanity. Never seen one this bad any thoughts on correcting this? Thanks everyone.

Regards,
Richard Middleton
Visit list archives, subscribe, unsubscribe or change your subscription preferences: http://stoneandtilepros.simplelists.com/sccpartners Start a new conversation (thread): sccpartners@stoneandtilepros.simplelists.com

<Marble Etching.jpg>