I agree with Pat-The densifiers will help with soiling and make the material rder so it will wear better.
Check out a product from ameripolish called SR2 as your final sealer-it will help soiling.
Of course the client will need to maintain this surface properly and that will be the key- 

On Mon, May 8, 2017 at 8:33 AM, Pat Staples <cpstaples@msn.com> wrote:

Yes it will help prevent against rapid soiling issues, It closes off the pours better so it will not allow soiling to get in so easy.  I personally would do both.


Thank you
Carl Staples
Classic Marble & Stone Restoration
610-356-4100
www.marblerestore.com



From: sccpartners@stoneandtilepros.simplelists.com <sccpartners@stoneandtilepros.simplelists.com> on behalf of Blain Haeg <blain@goldstandardfloorcare.com>
Sent: Monday, May 8, 2017 8:27 AM
To: sccpartners@stoneandtilepros.simplelists.com
Subject: Re: limestone densifier
 
Thanks for the info on using these densifier products, guys. But I'll go back to my original question....will a densifier prevent against rapid soiling issues, any more than using a high quality penetrating sealer?

Floor care experts specializing in natural stone, tile & grout, and carpet. Excellence and satisfaction always guaranteed. Free estimates. Call (512) 257



On May 8, 2017 5:45 AM, "Pat Staples" <cpstaples@msn.com> wrote:

Innovative Surface Solutions that makes the Cheetah pads and pucks has a Lithium Silicate Hardener that is good for concrete, cement based terrazzo, travertine and limestone surfaces. Its is a little more expensive then Stu's but I think it works great. I have used it on Concrete and limestone before.



http://www.innovativesurfacesolutions.com/store/p/152-Lithium-Silicate-Hardener.aspx

RTU Hardener For Concrete, Travertine, Limestone & Terrazzo. Lithium Silicate sealer, hardener and densifier for concrete, cement based terrazzo, travertine and ...





Thank you
Carl Staples
Classic Marble & Stone Restoration
610-356-4100
www.marblerestore.com



From: sccpartners@stoneandtilepros.simplelists.com <sccpartners@stoneandtilepros.simplelists.com> on behalf of Stuart Rosen <mail@stoneshine.com>
Sent: Sunday, May 7, 2017 8:02 PM
To: sccpartners@stoneandtilepros.simplelists.com
Subject: Re: limestone densifier
 
Concrete densifier gets applied at point during the job.
Those densifiers are formulated to harden and make less porous the concrete.
The limestone densifiers are applied a day before you start working.
It makes
Working the limestone easier and provides better results.
There is a link with a spec sheet attached to a previous email.

Sent from my iPhone

On May 7, 2017, at 5:39 PM, Baird Standish <bairdstandish@gmail.com> wrote:

Stu, what is the difference between this densifier and concrete densifiers? 


________________________________________
From the desk of
Baird Standish
Managing Partner
Facility Specialists, LLC
15 West Highland Ave. Suite E
Philadelphia, PA 19118

On May 7, 2017, at 4:43 PM, Stuart Rosen <mail@stoneshine.com> wrote:

Sorry Blain,
Correction- we have had many positive comments regarding the use of the product.

Sent from my iPhone

On May 6, 2017, at 7:11 AM, Ron Moore <rmoore@americanstonecare.com> wrote:

Blain,

If the sealer you used left a satin finish and its wearing where they have heavy traffic, I'm afraid dropping back down to 200 and removing the sealer is the only way to reproduce an even finish. In this business, its extremely important to educate your cient. In this case, you have done nothing wrong. The problem is that this material is soft and porous. You can density after 200 and again after 400. Then 800 and seal. Explain that there is nothing you can do to change the characteristics of the material they have. You may want to suggest a maintenance plan..... ;  ). $$$$$ Best of luck, check in any time. Cell 301.602.2307 Ron Moore

Ron

On Friday, May 5, 2017, Blain Haeg <blain@goldstandardfloorcare.com> wrote:
Ron,

I went up to 800 resins before polishing.


On May 5, 2017 9:15 AM, "Ron Moore" <rmoore@americanstonecare.com> wrote:
Blain,

What grit finish did you bring the floor to? Densifiers almost always have sealing properties. If you go this route, I believe you would need to re-hone, harden and seal.

Ron

On May 5, 2017 9:35 AM, "Blain Haeg" <blain@goldstandardfloorcare.com> wrote:
I'm looking for some guidance on whether using a limestone densifier is appropriate for an issue I'm having.

The customer had a honed limestone floor installed inside their home. The installer applied a topical sealer, to provide semi-gloss finish. After a couple of years, the sealer began to fail, so the customer contacted me to strip, hone, polish, and seal (solvent impregnator). The floor looked great, but after a few months the traffic areas began to show signs of excessive soiling. 

If I had used a densifier, could this have possibly prevented the soiling issues? If I were to apply the densifier now, would it be necessary to strip the floor first, to remove the impregnating sealer that I applied 6 months ago? 

No pictures. Recommendations?
Blain Haeg
Gold Standard Floor Care
512.257.3070 office
512.750.1242 cell
blain@goldstandardfloorcare.com
www.GoldStandardFloorCare.com

Check us out on: Facebook, Google+, Yelp, BBB, or Angie's List
 
Visit list archives, subscribe, unsubscribe or change your subscription 
preferences:
http://stoneandtilepros.simplelists.com/sccpartners
 
Start a new conversation (thread): 
sccpartners@stoneandtilepros.simplelists.com

 
Visit list archives, subscribe, unsubscribe or change your subscription 
preferences:
http://stoneandtilepros.simplelists.com/sccpartners
 
Start a new conversation (thread): 
sccpartners@stoneandtilepros.simplelists.com

 
Visit list archives, subscribe, unsubscribe or change your subscription 
preferences:
http://stoneandtilepros.simplelists.com/sccpartners
 
Start a new conversation (thread): 
sccpartners@stoneandtilepros.simplelists.com

 
Visit list archives, subscribe, unsubscribe or change your subscription 
preferences:
http://stoneandtilepros.simplelists.com/sccpartners
 
Start a new conversation (thread): 
sccpartners@stoneandtilepros.simplelists.com

 
Visit list archives, subscribe, unsubscribe or change your subscription 
preferences:
http://stoneandtilepros.simplelists.com/sccpartners
 
Start a new conversation (thread): 
sccpartners@stoneandtilepros.simplelists.com

 
Visit list archives, subscribe, unsubscribe or change your subscription 
preferences:
http://stoneandtilepros.simplelists.com/sccpartners
 
Start a new conversation (thread): 
sccpartners@stoneandtilepros.simplelists.com

 
Visit list archives, subscribe, unsubscribe or change your subscription 
preferences:
http://stoneandtilepros.simplelists.com/sccpartners
 
Start a new conversation (thread): 
sccpartners@stoneandtilepros.simplelists.com

 
Visit list archives, subscribe, unsubscribe or change your subscription 
preferences:
http://stoneandtilepros.simplelists.com/sccpartners
 
Start a new conversation (thread): 
sccpartners@stoneandtilepros.simplelists.com

 
Visit list archives, subscribe, unsubscribe or change your subscription 
preferences:
http://stoneandtilepros.simplelists.com/sccpartners
 
Start a new conversation (thread): 
sccpartners@stoneandtilepros.simplelists.com

 
Visit list archives, subscribe, unsubscribe or change your subscription 
preferences:
http://stoneandtilepros.simplelists.com/sccpartners
 
Start a new conversation (thread): 
sccpartners@stoneandtilepros.simplelists.com




--
Regards,
Stu Rosen
201-446-1200
www.stoneshine.com
www.mbstonecare.com