Baird,

Just to understand better, the floor is honed but client wants a wet look?

J

Sent from my BlackBerry® smartphone with Nextel Direct Connect

-----Original Message-----
From: Baird Standish <bairdstandish@gmail.com>
Date: Wed, 16 Feb 2011 08:31:40
To: Restoration and Maintenance<sccpartners@stoneandtilepros.com>
Reply-To:"Restoration and Maintenance" <sccpartners@stoneandtilepros.com>
Subject: [sccpartners] removing excess sealer from travertine

Hi,
We have been asked to correct a sealer problem.  My client recently
had a honed travertine floor installed.  They went to the tile store
and bought Superior Enhance and Seal and applied it themselves with a
sponge that was recommended to them.  It looked bad on the first go
round, so they applied another coat and now it is smeary and smudgy.
They say that the stone is darkened, so it must have absorbed into the
stone well enough.  I looked up the product and there is very little
info except that it is color enhancing and will give a wet look.  So
was looking for any tips on how to remove the excess.  Normally i
would try to polish out or maybe use a high grit twister pad.  But
this is a honed floor, so i don't want to mess up the finish.  Perhaps
a stripper would work, but then that would probably remove the sealer.
 If I were to go this route, what would be a good replacement sealer
(wet look).
Thanks.

--
________________________________________
From the desk of
Baird Standish
Managing Partner
Facility Specialists, LLC
1616 Walnut St.
Philadelphia, PA 19103
Phone: 215-732-7505
Fax: 215-546-9160

--
Powered by http://DiscussThis.com
Visit list archives, subscribe, unsubscribe or change your subscription preferences:
http://www.discussthis.com/members/sccpartners@stoneandtilepros.com
Start a new conversation (thread): sccpartners@stoneandtilepros.com