Superior sealers are sold by Tile Shop stores. The manufacturer is from Michigan if that will help you.
Again, we used on that staff alkaline stripper and it worked, you can also use Betco Ax-it stripper since it is honed finish. There is no need to use MEC
To achieve wet look buff the enhancer in and remember that a little sealer like that goes long way (thicker coat will dry slower).
Adam Bartos
BiO Tile
773-575-5515
Sent via BlackBerry from T-Mobile

-----Original Message-----
From: Baird Standish <bairdstandish@gmail.com>
Date: Wed, 16 Feb 2011 11:54:31
To: Restoration and Maintenance<sccpartners@stoneandtilepros.com>
Reply-To:"Restoration and Maintenance" <sccpartners@stoneandtilepros.com>
Subject: RE: [sccpartners] removing excess sealer from travertine

Ok. All great advice. I am going to the Tile Store now to get MSDS
sheets. On-line the Tile Store recommended treating with their
Pro-strip ( I checked that MSDS and it is a blend of Meth Chlor and
other typical stuff).  They also recommend it for Aqua-mix enhance n
shine. Aqua- mix recommends nano-scrub but used the exact same
language, so probably is same stuff/same company. Still can't get the
MSDS sheet for the original sealer online.
B

On Wednesday, February 16, 2011, Bill Selik <billselik@yahoo.com> wrote:
> If the customer wants a wet look you will have to polish it after stripping
>
>
>
>
> From: "flooramor@aim.com" <flooramor@aim.com>
> To: Restoration and Maintenance <sccpartners@stoneandtilepros.com>
> Sent: Wed, February 16, 2011 5:40:25 AM
> Subject: RE: [sccpartners] removing excess sealer from travertine
>
> Baird,
>
> Just to understand better, the floor is honed but client wants a wet look?
>
> J
>
>
> Sent from my BlackBerry® smartphone with Nextel Direct Connect
>
> -----Original Message-----
> From: Baird Standish <bairdstandish@gmail.com>
> Date: Wed, 16 Feb 2011 08:31:40
> To: Restoration and Maintenance<sccpartners@stoneandtilepros.com>
> Reply-To:"Restoration and Maintenance" <sccpartners@stoneandtilepros.com>
> Subject: [sccpartners] removing excess sealer from travertine
>
> Hi,
> We have been asked to correct a sealer problem.  My client recently
> had a honed travertine floor installed.  They went to the tile store
> and bought Superior Enhance and Seal and applied it themselves with a
> sponge that was recommended to them.  It looked bad on the first go
> round, so they applied another coat and now it is smeary and smudgy.
> They say that the stone is darkened, so it must have absorbed into the
> stone well enough.  I looked up the product and there is very little
> info except that it is color enhancing and will give a wet look.  So
> was
>  looking for any tips on how to remove the excess.  Normally i
> would try to polish out or maybe use a high grit twister pad.  But
> this is a honed floor, so i don't want to mess up the finish.  Perhaps
> a stripper would work, but then that would probably remove the sealer.
> If I were to go this route, what would be a good replacement sealer
> (wet look).
> Thanks.
>
>
> --
>________________________________________
> From the desk of
> Baird Standish
> Managing Partner
> Facility Specialists, LLC
> 1616 Walnut St.
> Philadelphia, PA 19103
> Phone: 215-732-7505 <tel:215-732-7505>
> Fax: 215-546-9160 <tel:215-546-9160>
>
> --
> Powered by http://DiscussThis.com  <http://discussthis.com/>
> Visit list archives, subscribe, unsubscribe or change your subscription preferences:
> http://www.discussthis.com/members/sccpartners@stoneandtilepros.com
> Start a new conversation (thread): sccpartners@stoneandtilepros.com
>
>
>
>
> --
> Powered by http://DiscussThis.com
> Visit list archives, subscribe, unsubscribe or change your subscription preferences:
> http://www.discussthis.com/members/sccpartners@stoneandtilepros.com
> Start a new conversation (thread): sccpartners@stoneandtilepros.com
>
>
>
> Powered by http://DiscussThis.com <http://www.discussthis.com>
>
>
> Visit list archives, subscribe, unsubscribe or change your subscription preferences
>  <http://www.discussthis.com/members/sccpartners@stoneandtilepros.com>
>
> Start a new conversation (thread) <sccpartners@stoneandtilepros.com>
>
>

--
________________________________________
From the desk of
Baird Standish
Managing Partner
Facility Specialists, LLC
1616 Walnut St.
Philadelphia, PA 19103
Phone: 215-732-7505
Fax: 215-546-9160

--
Powered by http://DiscussThis.com
Visit list archives, subscribe, unsubscribe or change your subscription preferences:
http://www.discussthis.com/members/sccpartners@stoneandtilepros.com
Start a new conversation (thread): sccpartners@stoneandtilepros.com