John,
They both the house with the floor already installed and they were never happy with it so they asked me for help.

I am thinking about using my truck mount to clean it, instead scc marble cleaner I will use my grout cleaner ( which is 14ph) and then 5x-it entire floor.

No guarantees except that the floor will be cleaned and look better.

Adam Bartos
Sent via BlackBerry from T-Mobile

-----Original Message-----
From: "John Freitag" <jfreitag@thestoneandtileschool.com>
Date: Fri, 17 Jun 2011 12:48:03
To: Restoration and Maintenance<sccpartners@stoneandtilepros.com>
Reply-To:"Restoration and Maintenance" <sccpartners@stoneandtilepros.com>
Subject: RE: [sccpartners] Grout residue

Adam.
First clean the floor sweep and then dust mop to remove most if not all the
sand from the floor. Then use a soft brush with neutral cleaner and apply a
lot of water and scrub the floor. The brush will or should remove most of
the loose sand from the grout lines. Then use your 5 X polishing powder and
repolish the floor. The 5X will remove the grout film from the stone.
however you can NEVER guarantee the customer the floor to be scratch free.

Question WHY do they have 1/2 inch grout lines ???? did the customer request
large grout line or did the installer just do the large grout lines ?

John E. Freitag
President/Director
The Stone and Tile School
Office 407-567-7652
Cell 407-615-0134
jfreitag@thestoneandtileschool.com

www.thestoneandtileschool.com

-----Original Message-----
From: Mike Marsoun [mailto:nulifesc@bigpond.com]
Sent: Thursday, June 09, 2011 7:40 AM
To: Restoration and Maintenance
Subject: RE: [sccpartners] Grout residue

this is a good one... My thoughts are along the lines of a razor very
carefully, buff with 3m aqua pad, then re polish. The acid in the polishing
compound should remove any remaining haze.
------Original Message------
From: info@restoreyourtiles.com
To: Restoration and Maintenance
ReplyTo: Restoration and Maintenance
ReplyTo: info@restoreyourtiles.com
Subject: [sccpartners] Grout residue
Sent: Jun 9, 2011 8:13 AM

Trying to pick your brains on how to remove sanded grout residue from
polished finish limestone with out scratching it. The grout lines are 1/2"
and grout, stone and residue were sealed.
Would you use twister pads? Any ideas?
Adam Bartos
BiO Tile
Sent via BlackBerry from T-Mobile

--
Powered by http://DiscussThis.com
Visit list archives, subscribe, unsubscribe or change your subscription
preferences:
http://www.discussthis.com/members/sccpartners@stoneandtilepros.com
Start a new conversation (thread): sccpartners@stoneandtilepros.com

Sent via BlackBerryR from Telstra
--
Powered by http://DiscussThis.com
Visit list archives, subscribe, unsubscribe or change your subscription
preferences:
http://www.discussthis.com/members/sccpartners@stoneandtilepros.com
Start a new conversation (thread): sccpartners@stoneandtilepros.com

--
Powered by http://DiscussThis.com
Visit list archives, subscribe, unsubscribe or change your subscription preferences:
http://www.discussthis.com/members/sccpartners@stoneandtilepros.com
Start a new conversation (thread): sccpartners@stoneandtilepros.com