Hi. Was wondering if anyone has experience with using a template mold to fabricate an epoxy (or otherwise) piece to replace a chip in a carved marble conference table edge (similar to how they replaced my tooth with a crown that duplicated the old tooth). I have another similar job involving a limestone moulding above a fireplace that spalled off.
Thanks much
Baird

________________________________________
From the desk of
Baird Standish
Managing Partner
Facility Specialists, LLC
15 West Highland Ave. Suite E
Philadelphia, PA 19118
Phone: 215-732-7505
Fax: 215-546-9160
www.facspecs.com