UFO
Mike Marsoun
(18 Mar 2021 23:39 EDT)
|
Re: UFO
Stephen Webb
(18 Mar 2021 23:42 EDT)
|
Re: UFO
Stuart Rosen
(19 Mar 2021 07:04 EDT)
|
Re: UFO
Stephen Webb
(19 Mar 2021 20:57 EDT)
|
Re: UFO
Mike Marsoun
(19 Mar 2021 22:49 EDT)
|
Re: UFO
Stephen Webb
(19 Mar 2021 22:51 EDT)
|
Re: UFO Mike Marsoun (20 Mar 2021 04:45 EDT)
|
Re: UFO
Stuart Rosen
(20 Mar 2021 09:33 EDT)
|
Re: UFO
Mike Marsoun
(21 Mar 2021 16:07 EDT)
|
Re: UFO
Stephen Webb
(21 Mar 2021 17:03 EDT)
|
Re: UFO
Mike Marsoun
(21 Mar 2021 17:14 EDT)
|
I get it! They always left an amazing finish too. Sent from my iPhone > On Mar 19, 2021, at 4:51 PM, Stephen Webb <stephen@newlifemarblerestoration.com> wrote: > > they are thin but harder resin so they work great on travertine and limestone. I get them from Eastern marble > >> On 3/19/2021 4:48 PM, Mike Marsoun wrote: >> I haven’t seen genesis resins anywhere. They seem like they would be too thin. >> >> Sent from my iPhone >> >>> On Mar 19, 2021, at 2:57 PM, Stephen Webb <stephen@newlifemarblerestoration.com> wrote: >>> >>> do you have genesis >>> resins? >>> >>>> On 3/18/2021 5:38 PM, Mike Marsoun wrote: >>>> I did a top today with my UFO and it was a disaster. This is the smaller single speed machine and it was bouncing after the first minute with each step. Ended up using a hand machine. Any recommendations for diamonds that may glide better. I was using Diamax Hurricanes. The matrix was too soft for the travertine. Need something with less contact area and or harder resin matrix. >>>> >>>> Sent from my iPhone >>>> Visit list archives, subscribe, unsubscribe or change your subscription >>>> preferences: >>>> http://stoneandtilepros.simplelists.com/sccpartners >>>> Start a new conversation (thread): >>>> sccpartners@stoneandtilepros.simplelists.com >>>> >>> -- >>> This email has been checked for viruses by Avast antivirus software. >>> https://www.avast.com/antivirus >>> >>> Visit list archives, subscribe, unsubscribe or change your subscription preferences: >>> http://stoneandtilepros.simplelists.com/sccpartners >>> Start a new conversation (thread): sccpartners@stoneandtilepros.simplelists.com >>> >> Visit list archives, subscribe, unsubscribe or change your subscription >> preferences: >> http://stoneandtilepros.simplelists.com/sccpartners >> Start a new conversation (thread): >> sccpartners@stoneandtilepros.simplelists.com >> > Visit list archives, subscribe, unsubscribe or change your subscription preferences: > http://stoneandtilepros.simplelists.com/sccpartners > Start a new conversation (thread): sccpartners@stoneandtilepros.simplelists.com >