Genesis are made by abrasive technology
They are good pads
They worked well on floor machines so I think they will work fine on a ufo

Sent from my iPhone

> On Mar 20, 2021, at 4:45 AM, Mike Marsoun <808stonecare@gmail.com> wrote:
>
> I get it! They always left an amazing finish too.
>
> Sent from my iPhone
>
>> On Mar 19, 2021, at 4:51 PM, Stephen Webb <stephen@newlifemarblerestoration.com> wrote:
>>
>> they are thin but harder resin so they work great on travertine and limestone. I get them from Eastern marble
>>
>>>> On 3/19/2021 4:48 PM, Mike Marsoun wrote:
>>> I haven’t seen genesis resins anywhere. They seem like they would be too thin.
>>>
>>> Sent from my iPhone
>>>
>>>> On Mar 19, 2021, at 2:57 PM, Stephen Webb <stephen@newlifemarblerestoration.com> wrote:
>>>>
>>>> do you have genesis
>>>> resins?
>>>>
>>>>> On 3/18/2021 5:38 PM, Mike Marsoun wrote:
>>>>> I did a top today with my UFO and it was a disaster. This is the smaller single speed machine and it was bouncing after the first minute with each step. Ended up using a hand machine. Any recommendations for diamonds that may glide better. I was using Diamax Hurricanes. The matrix was too soft for the travertine. Need something with less contact area and or harder resin matrix.
>>>>>
>>>>> Sent from my iPhone
>>>>> Visit list archives, subscribe, unsubscribe or change your subscription
>>>>> preferences:
>>>>> http://stoneandtilepros.simplelists.com/sccpartners
>>>>> Start a new conversation (thread):
>>>>> sccpartners@stoneandtilepros.simplelists.com
>>>>>
>>>> --
>>>> This email has been checked for viruses by Avast antivirus software.
>>>> https://www.avast.com/antivirus
>>>>
>>>> Visit list archives, subscribe, unsubscribe or change your subscription preferences:
>>>> http://stoneandtilepros.simplelists.com/sccpartners
>>>> Start a new conversation (thread): sccpartners@stoneandtilepros.simplelists.com
>>>>
>>> Visit list archives, subscribe, unsubscribe or change your subscription
>>> preferences:
>>> http://stoneandtilepros.simplelists.com/sccpartners
>>> Start a new conversation (thread):
>>> sccpartners@stoneandtilepros.simplelists.com
>>>
>> Visit list archives, subscribe, unsubscribe or change your subscription preferences:
>> http://stoneandtilepros.simplelists.com/sccpartners
>> Start a new conversation (thread): sccpartners@stoneandtilepros.simplelists.com
>>
>
> Visit list archives, subscribe, unsubscribe or change your subscription
> preferences:
> http://stoneandtilepros.simplelists.com/sccpartners
>
> Start a new conversation (thread):
> sccpartners@stoneandtilepros.simplelists.com
>