Arent they strictly nickel bond up to 600? I think the lower grits still might bounce because they will be super aggressive.

> On Mar 20, 2021, at 3:33 AM, Stuart Rosen <mail@stoneshine.com> wrote:
>
> Genesis are made by abrasive technology
> They are good pads
> They worked well on floor machines so I think they will work fine on a ufo
>
> Sent from my iPhone
>
>> On Mar 20, 2021, at 4:45 AM, Mike Marsoun <808stonecare@gmail.com> wrote:
>>
>> I get it! They always left an amazing finish too.
>>
>> Sent from my iPhone
>>
>>> On Mar 19, 2021, at 4:51 PM, Stephen Webb <stephen@newlifemarblerestoration.com> wrote:
>>>
>>> they are thin but harder resin so they work great on travertine and limestone. I get them from Eastern marble
>>>
>>>>> On 3/19/2021 4:48 PM, Mike Marsoun wrote:
>>>> I haven’t seen genesis resins anywhere. They seem like they would be too thin.
>>>>
>>>> Sent from my iPhone
>>>>
>>>>> On Mar 19, 2021, at 2:57 PM, Stephen Webb <stephen@newlifemarblerestoration.com> wrote:
>>>>>
>>>>> do you have genesis
>>>>> resins?
>>>>>
>>>>>> On 3/18/2021 5:38 PM, Mike Marsoun wrote:
>>>>>> I did a top today with my UFO and it was a disaster. This is the smaller single speed machine and it was bouncing after the first minute with each step. Ended up using a hand machine. Any recommendations for diamonds that may glide better. I was using Diamax Hurricanes. The matrix was too soft for the travertine. Need something with less contact area and or harder resin matrix.
>>>>>>
>>>>>> Sent from my iPhone
>>>>>> Visit list archives, subscribe, unsubscribe or change your subscription
>>>>>> preferences:
>>>>>> http://stoneandtilepros.simplelists.com/sccpartners
>>>>>> Start a new conversation (thread):
>>>>>> sccpartners@stoneandtilepros.simplelists.com
>>>>>>
>>>>> --
>>>>> This email has been checked for viruses by Avast antivirus software.
>>>>> https://www.avast.com/antivirus
>>>>>
>>>>> Visit list archives, subscribe, unsubscribe or change your subscription preferences:
>>>>> http://stoneandtilepros.simplelists.com/sccpartners
>>>>> Start a new conversation (thread): sccpartners@stoneandtilepros.simplelists.com
>>>>>
>>>> Visit list archives, subscribe, unsubscribe or change your subscription
>>>> preferences:
>>>> http://stoneandtilepros.simplelists.com/sccpartners
>>>> Start a new conversation (thread):
>>>> sccpartners@stoneandtilepros.simplelists.com
>>>>
>>> Visit list archives, subscribe, unsubscribe or change your subscription preferences:
>>> http://stoneandtilepros.simplelists.com/sccpartners
>>> Start a new conversation (thread): sccpartners@stoneandtilepros.simplelists.com
>>>
>>
>> Visit list archives, subscribe, unsubscribe or change your subscription
>> preferences:
>> http://stoneandtilepros.simplelists.com/sccpartners
>>
>> Start a new conversation (thread):
>> sccpartners@stoneandtilepros.simplelists.com
>>
>
> Visit list archives, subscribe, unsubscribe or change your subscription
> preferences:
> http://stoneandtilepros.simplelists.com/sccpartners
>
> Start a new conversation (thread):
> sccpartners@stoneandtilepros.simplelists.com
>