Baird I recently did a home that was limestone with an acrylic finish. We removed coating, and proceed to go 400 grit and 800 grit diamond with a vortex 1100 and man they loved it, of course we used an impregnator customer loved it

Sent by iPhone
Dayron Padilla
Perfect Marble

> On Aug 11, 2014, at 6:41 PM, Bstandish <bstandish@facspecs.com> wrote:
>
> Good afternoon. Am looking at project involving a 100+ year old limestone floor that needs to be stripped and honed to a satin finish. That is, I think, the easy part. Probably use vortex or similar and take up to 1100 grit or so. The question is- this is a place that is used for  parties and is subject to staining. Of course we could we coat with acrylic again, but that would not leave it much better than it is now.  Would an impregnating solvent-based sealer do the trick? If we go with a topical sealer, what to use that would retain the satin finish and would be easy to maintain over time?
> Thanks,
> Baird
>
>
> ________________________________________
> From the desk of
> Baird Standish
> Managing Partner
> Facility Specialists, LLC
> 15 West Highland Ave. Suite E
> Philadelphia, PA 19118
> Phone: 215-732-7505
> Fax: 215-546-9160
> www.facspecs.com
> Visit list archives, subscribe, unsubscribe or change your subscription
> preferences:
> http://stoneandtilepros.simplelists.com/sccpartners
>
> Start a new conversation (thread):
> sccpartners@stoneandtilepros.simplelists.com
>