Thanks sir

Sent from my iPhone

> On Jun 11, 2016, at 11:06 AM, John Freitag <jfreitag@thestoneandtileschool.com> wrote:
>
> Masonry cleaner  surclean 600
>
>
> John E Freitag
>
> John E Freitag
> Owner/Director
> The Stone & Tile School
> Office 407-567-7680
> Cell 407-615-0134
>
>
>
>
> www.thestoneandtileschool.com
>
>
>
> -----Original Message-----
> From: list-manager@stoneandtilepros.simplelists.com [mailto:list-manager@stoneandtilepros.simplelists.com] On Behalf Of Justin Cameron
> Sent: Saturday, June 11, 2016 11:58 AM
> To: sccpartners@stoneandtilepros.simplelists.com
> Subject: Re: Slate and porcelain
>
> Thank you Stu and John for the feed back. I was looking up prosco masonry cleaner and noticed a few options any specific one John?
> Thank you
>
> Sent from my iPhone
>
>> On Jun 11, 2016, at 7:29 AM, John Freitag <jfreitag@thestoneandtileschool.com> wrote:
>>
>> Your going to need to use an acid based cleaner. I would recommend
>> Prosco Masonry Clea John E Freitag
>>
>> John E Freitag
>> Owner/Director
>> The Stone & Tile School
>> Office 407-567-7680
>> Cell 407-615-0134
>>
>>
>>
>>
>> www.thestoneandtileschool.com
>>
>> ner  600 dilute more than recommended , be sure to wear safety glasses and rubber gloves. Apply with a sponge do not spray.
>> Allow dwell time with a scraper , then brush vac rinse , this will probably take two applications , after the acid then clean with a neutral cleaner to neutralize the surface. This will work on the porcelain and the slate. If the slate need  more attention you can use a honing powder or honing pad to remove the remainder and give a new honed surface to the slate. When completed seal with an impregnating sealer or to enhance the color use a color enhancing sealer , solvent based.
>>
>>
>>
>> -----Original Message-----
>> From: list-manager@stoneandtilepros.simplelists.com
>> [mailto:list-manager@stoneandtilepros.simplelists.com] On Behalf Of
>> Justin Cameron
>> Sent: Friday, June 10, 2016 7:22 PM
>> To: Stone Tile Pros
>> Subject: Slate and porcelain
>>
>> Wanting some suggestions on restoring this water feature in a spa. 🙀😬. The walls are porcelain and the bottom ledge is slate. All are really bad hard water damage wondering best way to restore or is it waste of time.
>> Thanks
>> Justin
>>
>>
>> Visit list archives, subscribe, unsubscribe or change your
>> subscription
>> preferences:
>> http://stoneandtilepros.simplelists.com/sccpartners
>>
>> Start a new conversation (thread):
>> sccpartners@stoneandtilepros.simplelists.com
>>
>>
>>
>>
>> Visit list archives, subscribe, unsubscribe or change your
>> subscription
>> preferences:
>> http://stoneandtilepros.simplelists.com/sccpartners
>>
>> Start a new conversation (thread):
>> sccpartners@stoneandtilepros.simplelists.com
>
> Visit list archives, subscribe, unsubscribe or change your subscription
> preferences:
> http://stoneandtilepros.simplelists.com/sccpartners
>
> Start a new conversation (thread):
> sccpartners@stoneandtilepros.simplelists.com
>
>
>
>
>
> Visit list archives, subscribe, unsubscribe or change your subscription
> preferences:
> http://stoneandtilepros.simplelists.com/sccpartners
>
> Start a new conversation (thread):
> sccpartners@stoneandtilepros.simplelists.com
>