Carrera high shine polish Tony Deluna (07 May 2018 20:59 EDT)
Re: Carrera high shine polish Justin Cameron (07 May 2018 21:03 EDT)
Re: Carrera high shine polish Stuart Rosen (07 May 2018 21:19 EDT)
Re: Carrera high shine polish Bob Murrell (07 May 2018 21:20 EDT)
Re: Carrera high shine polish Kevin L. Hudson (08 May 2018 06:49 EDT)
Re: Carrera high shine polish Ace Siler (08 May 2018 10:46 EDT)
Re: Carrera high shine polish Mike Marsoun (09 May 2018 14:06 EDT)
Re: Carrera high shine polish Tony Deluna (10 May 2018 00:24 EDT)
Re: Carrera high shine polish Tony Deluna (08 May 2018 16:43 EDT)

Re: Carrera high shine polish Mike Marsoun 09 May 2018 14:06 EDT

The whites can take some extra honing to close up the pores before polishing. I would hone to 1800 or even 3000. Thassos is the worst.

Sent from my iPhone

> On May 8, 2018, at 4:46 AM, Ace Siler <bellastonecare@gmail.com> wrote:
>
> What diamonds do you use? Maybe go lower?
>
> Sent from my iPhone
>
>> On May 8, 2018, at 3:48 AM, Kevin L. Hudson <klhudson@atlantastoneandtilecare.com> wrote:
>>
>> Tony,
>> I had a similar issue a few weeks ago! As Justin stated MB- 22 worked nicely!
>>
>> Kevin L. Hudson
>> N-Motion Stone and Tile Restoration
>> klhudson@atlantastoneandtilecare.com
>> (678) 662-0110
>>
>>
>>> On May 7, 2018, at 9:20 PM, Bob Murrell <bmurrell@m3techinc.com> wrote:
>>>
>>> Tony, you might try the Majestic “golden” 5X. It is much finer because it is ball-milled and is made from the very best potassium oxalate and aluminum oxides. If normally works very well on the Carrera.
>>>
>>>
>>> Sent from Bob Murrell's iPhone
>>> M3 Technologies, Inc.
>>> 865-607-0957
>>> Office 800-342-4533
>>> www.go2m3.com
>>>
>>>
>>>> On May 7, 2018, at 9:04 PM, Justin Cameron <justin@jmcstoneandtilecare.com> wrote:
>>>>
>>>> Mb-22
>>>> From Stu
>>>>
>>>> Sent from my iPhone
>>>>
>>>>> On May 7, 2018, at 5:58 PM, Tony Deluna <tndeluna@gmail.com> wrote:
>>>>>
>>>>> Hey Guys, what compound do you use to produce a high shine polish on Carrera marble?
>>>>>
>>>>> I’ve done it many times but for some reason it’s not been working too well lately.
>>>>>
>>>>> After 800 I tried 5x, Dai-glo, Tenax, Pinnacle, Revive by Aquamix, the old mb-12 from 14yrs ago, mb-20,
>>>>>
>>>>> I even took it to 3000 then the resin buff pad. But I had a couple bad spots and made it worse by using compound in a small spot. Very little too just for a test. It turned orange peel and got dull.
>>>>>
>>>>> Fortunately it’s a small table someone dropped off.
>>>>>
>>>>> What do you think guys?
>>>>>
>>>>>
>>>>> Tony DeLuna
>>>>> 925-625-9625
>>>>> www.PatriotStoneRestoration.com
>>>>>
>>>>> Visit list archives, subscribe, unsubscribe or change your subscription
>>>>> preferences:
>>>>> http://stoneandtilepros.simplelists.com/sccpartners
>>>>>
>>>>> Start a new conversation (thread):
>>>>> sccpartners@stoneandtilepros.simplelists.com
>>>>>
>>>>
>>>> Visit list archives, subscribe, unsubscribe or change your subscription
>>>> preferences:
>>>> http://stoneandtilepros.simplelists.com/sccpartners
>>>>
>>>> Start a new conversation (thread):
>>>> sccpartners@stoneandtilepros.simplelists.com
>>>>
>>>
>>> Visit list archives, subscribe, unsubscribe or change your subscription
>>> preferences:
>>> http://stoneandtilepros.simplelists.com/sccpartners
>>>
>>> Start a new conversation (thread):
>>> sccpartners@stoneandtilepros.simplelists.com
>>>
>>
>> Visit list archives, subscribe, unsubscribe or change your subscription
>> preferences:
>> http://stoneandtilepros.simplelists.com/sccpartners
>>
>> Start a new conversation (thread):
>> sccpartners@stoneandtilepros.simplelists.com
>>
>
> Visit list archives, subscribe, unsubscribe or change your subscription
> preferences:
> http://stoneandtilepros.simplelists.com/sccpartners
>
> Start a new conversation (thread):
> sccpartners@stoneandtilepros.simplelists.com
>